Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
See the difference
Before
After
Before
After
Before
AfterHow Much Does Duct Repair & Sealing Cost in Fordham?
Duct repair and sealing in Fordham typically runs about $250 to $1,400 for most residential jobs, with the broad middle of the range landing between $400 and $850. A single accessible leak is on the low end; a house with damaged trunk lines, disconnected runs, and multiple leak points pushes toward the top. Every job is priced per job from a written estimate, and the estimate itself is free.
Call (833) 901-6929. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Most Fordham duct repair and sealing jobs land between $400 and $850.
- The written estimate sets the final price – there is no fee to get one.
- Leaks found during cleaning can usually be sealed on the same visit.
- Sealing pays back through lower heating and cooling bills, not just comfort.
- We use professional-grade equipment from Rotobrush, Nikro, Abatement Technologies, Honeywell, and Aprilaire.
Duct Repair & Sealing Cost Breakdown (2026)
The table below shows typical duct repair & sealing pricing for the Fordham market in 2026. Ranges are estimates, not quotes. The written estimate you receive after the inspection is the number that matters.
| Line item | Typical range |
|---|---|
| Full duct inspection and leak assessment | $0 – included with cleaning or repair visit |
| Small leak repair (single joint, one accessible run) | $150 – $300 |
| Sealant application, mastic or foil tape, per run | $80 – $180 |
| Refastening or reconnecting a disconnected run | $120 – $250 |
| Trunk line repair (main supply or return) | $300 – $700 |
| Replacing a damaged section of flex or sheet metal duct | $250 – $600 per section |
| Sealing an entire small home’s duct system | $500 – $900 |
| Sealing an entire larger home’s duct system | $900 – $1,400 |
| Insulation repair on attic or crawlspace ductwork | $200 – $500 |
Most Fordham homeowners never need every line on that table. The common scenario is a home with two to five leaks, one problem run, and old tape that has dried out and let go. That kind of job usually prices out between $400 and $850. The price climbs when the ducts are in hard-to-reach places – a low crawlspace, a tightly packed attic, or a chase inside a wall – or when the system has been leaking so long that the insulation itself is soaked and needs replacing.
Where the price comes down is when the damage is concentrated. One joint that came apart at a register boot is quick work. It’s the scatter of small leaks across a whole system that adds up, because each one takes time to reach, clean, and seal properly.
If you’re already having the ducts cleaned, sealing is cheaper as an add-on than as a standalone visit, because the technician is already in the system. That’s part of why we handle air duct cleaning Fordham and sealing under one roof – nothing gets passed to a second contractor.
What Affects Duct Repair & Sealing Pricing in Fordham
Six things move the number up or down. Each one is something we check during the inspection, and each is something you can ask about when you get your estimate.
- Number of leaks. A single leak is a small job. A system leaking at every joint takes considerably longer to seal, and the price reflects the number of points the technician has to reach and treat.
- Access. Ducts in a basement are easy. Ducts in a low crawlspace, a cramped attic, or a chase behind finished walls are slow work, and slow work costs more. Fordham’s mix of older homes and multifamily buildings means plenty of both.
- Duct material. Flex duct and sheet metal fail differently and are repaired differently. Sheet metal often needs fasteners and mastic; flex needs the inner liner reconnected properly and the outer jacket sealed. The material determines the method, and the method determines the time.
- Whether insulation is damaged. If the duct insulation is torn, compressed, or wet, sealing alone isn’t enough – the insulation needs replacing too, which adds a line to the estimate.
- Size of the system. A one-bedroom unit and a four-bedroom house aren’t the same job. More runs means more joints, more length, and more time.
- Whether it’s combined with cleaning. A standalone sealing visit costs more than sealing done during a cleaning, because the system has to be opened up either way. When the two happen together, you pay for the access once.
One more factor worth naming: the condition the system was found in. A house where the ducts have been running with a long-standing leak collects dust and debris at the leak point, and the technician has to clean that area before sealing it, or the seal won’t hold. That’s part of why we pair sealing with HVAC cleaning in Fordham when the system hasn’t been serviced in a while.
How Duct Leaks Get Found in Fordham
You can’t price a repair until you know what’s leaking. That’s the first step on every sealing job, and it’s the part most homeowners never see.
The inspection looks at the whole air pathway. We check the supply and return sides, the connection points at the air handler, and the joints along each run. Loose tape, gaps at register boots, and disconnected flex at fittings are the common finds. So is a trunk line that’s pulled apart at a seam. In homes where the ducts run through an unconditioned attic or crawlspace, we look at the insulation too, because ductwork that’s lost its insulation is leaking heat even when the metal is intact.
Why does this matter for price? Because the inspection is what turns a range into a real number. A homeowner who gets a phone quote for “duct sealing” is often quoted a flat rate for a job nobody has looked at. Once the technician is on site, the scope changes and so does the price. We’d rather find the leaks first, then quote the repair, so the estimate you sign is the price you pay.
If you’ve noticed rooms that never get warm in winter, or a utility bill that’s crept up without explanation, that’s the pattern that usually points to leaky ducts. Sealing is one of the few home repairs with a visible payback. We aren’t going to promise a percentage savings, because every house is different – but we will tell you which leaks we found and what each one is costing you in lost conditioned air.
What a Typical Duct Sealing Visit Involves
Most jobs follow the same sequence, and knowing it helps you understand what you’re paying for.
- Inspection. The technician inspects the ductwork, identifies leaks, and documents what needs repair.
- Cleaning the area around each leak. Dust and debris are removed so the sealant or mastic can bond properly.
- Repair. Disconnected runs are reconnected. Damaged sections are repaired or replaced.
- Sealing. Every joint and seam in the repair scope gets sealed with mastic or a proper foil product – not contractor-grade cloth tape that dries out and lets go within a season or two.
- Verification. The technician checks the sealed sections and confirms airflow at the registers before packing up.
Most of this happens in a single visit. That matters because a separate contractor for repair and a separate visit for sealing means paying twice for the same setup. We handle both, which is also why we offer dryer vent cleaning in Fordham as its own visit when the system needs the full pathway cleared.
Safety note
Flexible duct runs and register boots near mechanical rooms can sit close to the furnace or air handler and, in some setups, near gas connections. We don’t recommend homeowners reseal or reconnect ductwork near a gas line or on the combustion-air side of the equipment. That work should go to a trained professional who can confirm the equipment is safe to operate afterward. We’ll flag anything we find in that zone so it gets handled properly.
How to Save on Duct Repair & Sealing
There’s no magic discount, but there are real ways to keep the number down.
- Get the estimate before work starts. Our estimate is free, and a written scope keeps the price from drifting once the technician is on site. Call (833) 901-6929 and book an inspection.
- Bundle sealing with cleaning. If the ducts are due for cleaning anyway, doing both on one visit costs less than two separate appointments.
- Fix leaks when they’re small. A $150 joint repair today can become a $600 trunk line repair once the leak has soaked the insulation and pulled the duct apart.
- Ask for the scope in writing. A legitimate estimate lists which runs are being sealed and what’s being repaired. A flat “duct sealing” price with no scope is a red flag.
- Don’t seal over dust. Skipping the cleaning step means the sealant fails and you pay twice. Good sealing work starts with a clean surface.
- Consider your whole air system. If the attic ducts are shot, the payback from sealed ducts is diluted by an HVAC unit that hasn’t been serviced. Ask for the air quality and sanitizing service assessment at the same time if indoor air is your concern.
We use professional-grade equipment from brands including Rotobrush, Nikro, and Abatement Technologies on every job, because improvised tools leave gaps that a shop vacuum can’t reach. Honeywell and Aprilaire products come into play on the air quality side. The point isn’t the brand labels – it’s that the equipment can actually do the sealing work correctly the first time.
Duct Repair or Full Replacement? How to Decide
Repair is usually the right call. Replacement makes sense when the ductwork is failing across most of its length, when it’s undersized for the equipment, or when insulation is damaged throughout. A short section repair never makes sense on a system that’s collapsing everywhere.
The honest answer is that you can’t know which you’re facing until someone has looked. That’s what the inspection is for. If you’re comparing options, our guide to repair versus replacement walks through how to think about it. And if you’re a property manager dealing with a multifamily building in Fordham, scope per unit matters – sealing one unit at a time keeps costs predictable and caps the disruption.
Why Choose a Duct Repair Specialist Over a Cleaner
Plenty of companies clean ducts. Far fewer can repair and seal them. When a cleaner finds a leak, the usual outcome is a referral to a separate contractor and a second visit. That means two inspections, two estimates, and two sets of scheduling headaches.
We handle the whole pathway in one place. Cleaning, sealing, repair, HVAC cleaning, dryer vent cleaning, and air quality work all come from the same team. It’s a practical difference for a homeowner, and it’s an even bigger one for a property manager coordinating several units.
You can read more about our full-service approach on the duct sealing service page, or explore our residential duct services and commercial duct services pages depending on the property. For a broader picture of how sealing fits into overall air system maintenance, see our duct cleaning cost guide and the indoor air quality overview.
FAQs – Duct Repair & Sealing Cost
How much does duct repair and sealing cost in Fordham?
Most Fordham jobs run $250 to $1,400, with a typical job between $400 and $850. The low end covers a single small leak; the top of the range covers sealing a whole home’s system with multiple repairs. The written estimate sets the exact price. Call (833) 901-6929 for a free estimate.
Is duct sealing worth the money?
For a home with real leaks, yes. Sealing stops conditioned air from escaping into attics, crawlspaces, and wall cavities, which is air you’ve already paid to heat or cool. Whether it pays back for you depends on how leaky the system is and how long you plan to stay. Our estimate will tell you which leaks we found so you can weigh the cost against the savings.
Can you repair and seal ducts in one visit?
Usually, yes. Inspection, repair, and sealing happen on the same visit for most residential jobs. Complex systems or extensive damage may need a second appointment once the scope is clear. Call (833) 901-6929 and we’ll confirm what’s involved for your home.
How much does it cost to seal just one duct run?
A single run with one leak typically costs $150 to $300, and sealant application adds $80 to $180 depending on length. That’s a smaller line than a whole-system job, and it’s often the right starting point if you have one obvious problem run. Call (833) 901-6929 for a written estimate.
Why are my ducts leaking in the first place?
Most leaks come from three things: tape that has dried out and let go, joints that were never properly sealed in the first place, and flex duct that’s been pulled loose at a fitting. Age and attic heat accelerate the process. An inspection confirms which of these applies in your home before any pricing is final. Call (833) 901-6929 to get one scheduled.
Call (833) 901-6929. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Every estimate is free, and every job is priced per job from the written estimate before any work starts.
Pricing reflects the Fordham market as of 2026. Air Duct Cleaning Fordham offers free estimates – call (833) 901-6929.
Written by the team at Air Duct Cleaning Fordham.
What Our Customers Say
"Job was done well and the house smells better. There was some dust knocked loose around a couple of the registers that I had to wipe down afterward."
- Sarah Anderson"Told me straight that our ducts were in decent shape and didn't need doing every year like the mailer companies claim."
- Marcy Gallagher"Ran a negative air machine on the whole system rather than the shop vac on a stick that the cheap outfit down the road uses. Showed me the before and after photos from inside the trunk line and it was genuinely disgusting."
- Shannon Novak